Diamond Fold Card

There is one day left in the June Scor-pal More than One Score Challenge - Pretty in Pink. I am getting this card in under the wire! I am also entering it in the Simon Says Stamp Wednesday Challenge - Anything Goes.

I am not sure what this type of fold is called, but I am calling it a Diamond fold. I started with a piece of black cardstock that measured 8.5" x 5.5". With the long side on top, I scored at 2.75" and 4". With the short side on top, I scored at 2.75". With the long side on top again, I scored from the top of the 2.75" score line to the middle of the 4"score line and then from there to the bottom of the 2.75" score line. This is what it looks like:

Crease all the fold lines well and have the two diagonal folds and the fold on the right as mountain folds and the rest as valley folds. Bring the two left corners up and together and push to the right. It should form the diamond shape in front. 

I cut patterned paper to 2.5" x 4.25" and 2.5" x 2.5" and taped it to the front of the card and the diamond with Scor Tape. I also cut a small piece for the small section to the left of the diamond, but I didn't measure it.

I stamped the flower, leaves and sentiment and cut them out with dies. I matted the sentiment with a punched circle and taped it on the diamond. I attached the flower and leaves with foam squares.

I used the following products:

Gina K. Designs: ink: Lovely Lavender, Wild Lilac, Wild Dandelion, Grass Green 
                             stamp sets: Layered Daisies, Rose Peonies, and coordinating dies
Cottage Cutz Stitched Circle die
Recollections 2 inch circle punch
Scor Tape, Scor-Pal

patterned paper from Cardmaking & Papercraft magazine

Black cardstock, foam squares from my stash

Washi Tape Card

This is my last card for the StampTV Monthly Mix challenge - Gray is the New Black. We need to use gray as a main colour on our project. I am also entering it in the Simon Says Stamp Wednesday challenge - Anything Goes.

I liked the combination of gray and red that I used on my last card, so I decided to use it again. I stamped the flower and leaves, coloured them in with alcohol markers, and cut them out with the matching dies.

I took a piece of cardstock, adhered washi tape to it and taped it to a piece of gray cardstock. I matted it with red and attached it to a white card base. I stamped the sentiment in black and heat embossed it with clear embossing powder. I popped up the flower and leaves with some foam squares.

Supplies used:
Gina K. Designs: Rose Peonies stamp set and coordinating dies
Spectrum Noir: Ultra Smooth Premium White Cardstock
                          Alcohol markers: RB2, CR8, DR3, DG2, DG3, CT4
Memento Tuxedo Black ink
clear embossing powder, washi tape, foam squares, gray and red cardstock from my stash

Merry Christmas

This is another card I made for the StampTV Monthly Mix Challenge - Gray is the New Black.  

I saw a gray card with white embossing on Pinterest and that sparked the idea for this card. It was quick and easy.

I stamped the trees on a piece of gray cardstock with VersaMark ink and heat embossed them in white. Then I stamped the sentiment and heat embossed it in red. I smeared some white pigment ink on an acrylic block, added a bit of water and used a water brush to pick up some ink and spray it on the background to look like snow.

I adhered this to a red mat and attached it to a white card base.

Supplies used:
Gina K. Designs: Merry & Bright, Seasonal Sentiments Stamp sets
                            White base weight cardstock
VersaMark ink
ColorBox Frost White pigment ink
Kuretake water brush
White and red embossing powder, gray and red cardstock

Business Card Holder

I was looking on Pinterest the other day and saw this business card holder. I decided to make it and enter it in the Scor-Pal More than one Score challenge - Pretty in Pink. We have to make something that has more than one score line and has pink on it.

Using a piece of pink cardstock measuring 8.25" x 6", I scored at 1.5", 2.25", 5.25" and 6" on the long side, and at 1" and 5" on the short side. I folded along all of the score lines. Holding it with the long side on top, I cut along the score lines at 1.5" and 6" up to the first score line. I repeated this on the other side. I then cut off the part in between along the 1" score line. I was left with this shape:

I folded up the sides to make a U shape and then folded down the ends. Here is what it looks like from the side:

I added Scor-tape to the sides of the U and folded them in toward the middle. This forms the base of the holder. I added more Scor-tape on the ends and fastened them together. On each end, I cut off a triangle from the back to the top off the side. I added patterned paper from the Crate Paper - Oh Darling paper pad and punched a small semicircle in the front with a 2" circle punch.

This makes a holder that is 1.5" deep. The Pinterest article had measurements in metric and imperial and I think the imperial measurements are a bit off. If I made this again, I would start with a 7.5" x 5.75" piece of cardstock and score at 1.5", 2.25", 4.75" and 5.5" on the long side and at 1" and 4.75" on the short side. This would give a holder that is 1" deep.

Father's Day Card

Since Father's Day is coming up, I thought I better get a card made! I am entering this in the following challenges: StampTV Monthly Mix Challenge - Gray is the New Black and Die Cuttin' Divas - Masculine or Father's Day.

I started with a piece of gray cardstock and embossed it with an embossing folder. I die cut another piece of gray and stamped the bird images and sentiment with Sandy Beach ink. The sentiment looked a bit light so I stamped it again using Ocean Mist. I tried to slightly offset it to get a shadow effect but I think I was a little crooked. I coloured the birds with coloured pencils.

I stamped the sailboats on a piece of blue cardstock and matted the focal image and background with blue. I die cut the smaller mat out of the piece that I used for the larger mat to save cardstock.

I attached everything to a white card base with a tape runner. I was finishing the inside of the card and accidentally touched the front of the card to the Ocean Mist ink pad. I tried to erase it and it is lighter but you can still see it in the sentiment. Sigh.


Supplies used:
Gina K. Designs: By the Sea Stamp set
                            Sandy Beach, Ocean Mist ink
                            Ocean Mist cardstock
Cottage Cutz Stitched Square dies
Lifestyle Crafts GooseBumpz Zig Zag embossing folder
Laurentien coloured pencils
tape runner, white and grey cardstock from my stash

Come to the Dark Side

This week, for the Mod Squad challenge we are to Come to the Dark Side. We have to colour an image on dark cardstock. I am also entering this in the StampTV Monthly Mix challenge - Gray is the New Black. We have to use gray as a main colour on our project.

I didn't have any gray cardstock that was dark enough, so I used a piece of white cardstock and sponged Slate ink over it. I stamped the flowers with VersaMark ink and embossed them with white embossing powder. I coloured them with some soft pastels, that seem more like chalk to me, and used a paper blending stump to smooth out the colour. I added some highlights with coloured pencils.

I stamped the sentiment and heat embossed it in white. I like this sentiment as it works for many occasions.

I matted this layer with pink and adhered it to a white card base. I added a bow to finish it off.

These are the supplies I used:
Gina K. Designs: White layering weight cardstock 
                             Slate ink
                             Especially for You Stamp set
VersaMark ink
Mungo soft pastels
Laurentien coloured pencils
Mini Glue Dots
paper blending stumps, pink cardstock, white embossing powder, ribbon, sponge dauber, tape runner         from my stash

Flowers and Bling

Today I made a card for a few challenges: StampTV Monthly Mix - Rainbow Stenciling; Mod Squad challenge - Florals-Pop up and Bling; and Simon Says Stamp Wednesday challenge - Use more than one Stamp.

I started by stencilling on a piece of white cardstock with a rainbow of colours. I didn't want to lose any of the center of the design, so I cut it in half and trimmed it down so it would fit on the black piece, cut to 4 1/8" x 5 3/8", and leaving a strip of black showing in the middle.

I stamped the sentiment and heat embossed it in white. I cut out the flower shapes with the die and then stamped the flowers and stems. 

I adhered the black piece onto a white card base, attached everything else and popped the flowers up with some foam squares.

I used the following supplies:
Gina K. Designs: Ink: Red Hot, Sweet Mango, Wild Dandelion, Jelly Bean Green, Turquoise Sea,                                          Wild Lilac, Peach Bellini 
                            Birthday Blessings stamp set
                            Layered Daisies Stamp set with coordinating die
                            White layering weight cardstock
VersaMark ink
white embossing powder, black cardstock, stencil, rhinestones, foam squares from my stash

 

Another Thank You Card

This is the second thank you card I made. I am also entering it in the following challenges:  StampTV Monthly Mix - Rainbow Stenciling; Simon Says Stamp Monday challenge - Stencil It; and Simon Says Stamp Wednesday challenge - Stencil It.

I stencilled the background onto a piece of white cardstock. I matted it with black and attached it to a white card base.

I had made two of the large sentiment for the last card so I used the second one on this card. (I had stamped it, heat embossed it, foiled it with silver and matted it with black.) I attached this to the card and added a few rhinestones to finish it off.

I used the following supplies:
Gina K. Designs: Massive Messages Stamp set
                            Ink: Dusty Rose, Peach Bellini, Lemon Drop, Applemint, Powder Blue, Lovely                                              Lavender 
                            Silver Sequins Fancy Foil
                            White cardstock 
Memento Tuxedo Black ink 
stencil, clear embossing powder, black cardstock, rhinestones from my stash

Stencilled Thank You Card

I needed to make a couple of thank you cards so I decided to use a stencil and enter the following challenges: StampTV Monthly Mix - Rainbow Stenciling; Simon Says Stamp Monday challenge - Stencil It; and Simon Says Stamp Wednesday challenge - Stencil It.

I started with a piece of white cardstock, taped the stencil down and sponged with a rainbow of soft colours. I matted this with a piece of black cardstock and attached it to a white card base.

I stamped the large sentiment and heat embossed it in clear. I cut it out using my electronic cutting machine and also cut out a mat in black. I used a laminating machine to foil the sentiment, layered it onto the mat and attached it to the card. I tied a bow onto a button and adhered it to the card with a Glue Dot.

I used the following supplies:

Gina K. Designs: Massive Messages Stamp set
                            Ink: Dusty Rose, Peach Bellini, Lemon Drop, Applemint, Powder Blue, Lovely                                             Lavender 
                            Silver Sequins Fancy Foil
                            White cardstock 
Memento Tuxedo Black ink 
Glue Dot
stencil, clear embossing powder, black cardstock, button and baker’s twine from my stash

Tone on Tone

There was a new release from Gina K. Designs this week and we are asked to make a Tone on Tone card for the Release Party Challenge. I am also entering this in the Mod Squad Challenge - Love and Support. We are to make a supportive card and it must have purple ribbon on it.

All products are Gina K. Designs unless specified.

I started with a piece of Wild Lilac cardstock and stamped the flourish randomly with Wild Wisteria ink to make a background.

I stamped the flowers onto a piece of white cardstock with Wild Lilac ink and the outline with Edible Eggplant, which is a very dark purple. I cut them out with the matching dies.

I stamped the sentiment with Wild Wisteria and cut it out with a die from my stash. I sponged around the edge, also with Wild Wisteria.

Since I didn’t have any purple ribbon, I used a piece of white ribbon from my stash and coloured it by rubbing the Wild Wisteria ink pad over it. 

After the ribbon was dry, I adhered it to the background with Tombow Mono adhesive and then attached that to a white card base. I added the sentiment and one of the flowers and then used foam squares from my stash to adhere the other two flowers.